Pulling – Elongation

The VP 505 pulling bench allows you to draw semi-automatically, without any effort any kind of wire

For copper and aluminum, range of diameters from 0.3 to 5.0 mm

• Very accurate guiding system
• Pneumatic jack pulling help
• Measurement repeatability
• Robust and reliable for a better life length
• Range of diameters from 3 to 3.5 mm for steel and stainless steel
• Range of diameters from 3 to 5.0 mm for copper and aluminum
• Range of diameters depending on elasticity for the other materials

For the fine or ultra-fine dies, we advise to check the dies diameter by elongation, that means the real wire elongation between each die

This is mainly advised for

• The final dies of your multiwire dies sets < 0.20 mm
• The ultra-fine dies sets (< 50 µm)

The elongation device, developed and used by Balloffet guarantees :

• Measurement precision at 0.1%
• Easy to use
• Longevity